There are a number of issues that can crop up while you pair your Circle device with your Wi-Fi network. We built a helpful walkthrough of Circle pairing to help you isolate the problem and get it resolved. Take a look below!
Additionally, you can check out the list of potential issues below for possible causes and resolutions. Is your issue not on the list? Use the search bar above, or contact support using the links at the bottom of this page.
Circle device is in a "dead zone"
Please ensure that your Circle device is able to successfully connect with your router, by placing it about 3-5 feet away, and avoid placing it in cabinets or other "heavy" furniture that may weaken the wireless signal.
Wi-Fi list does not fill
Make sure that your device being used to set up your Circle device is connected to the Circle device hotspot, and hasn't switched back over to your home network. You can ensure this isn't happening by enabling Airplane mode to disable cellular data, and "forgetting" your home network(s) in your device's Wi-Fi settings.
Update your admin. device and app
Make sure that your admin. device with the Circle app is fully updated. As well, make sure that the Circle Parental Controls app is up to date. If this is your first time pairing you might also need to update the firmware.
Should you continue to have an issue setting up a new Circle, leave the unit plugged in overnight to your router via Ethernet. This will allow the unit to update its firmware overnight. You can then try to setup again the next day.
Before proceeding through set up we recommend turning off data for your device, and as well any smart WiFi switching or what's called "WiFi assistant". This will keep your device from connecting to another source for Internet access during set up since the Circle Hotspot does not have Internet access and used only during set up.
In rare circumstances, a router's firewall might be intercepting the connection between the Circle device and the internet after pairing completes, or even in the pairing process. Check out this article for instructions on what to check for in your router's configuration to ensure communication between your Circle device and the Internet is allowed.
Your network doesn't have a password
Your home network should have a wireless password associated with it, in order to join. If it doesn't, you'll have to set one up; contact your ISP or router manufacturer for help with this. There is also a security benefit to this, so we recommend adding a password for that reason alone!
Cannot find Circle
If you're getting a message stating that Circle cannot be found when attempting to pair it to your Wifi, try turning off Cellular Data and going through the process again.
Hotspot password isn't working
If you've just reset your Circle and are trying to set it up again from scratch, on occasion the Circle may display the password from before the factory reset. Instead of the displayed password, try mycircle.